GM assume 52 ingegneri all'Engineering Centre di Torino

Euro engineering, società del gruppo Adecco specializzata in consulenza ingegneristica, seguirà la selezione dei 52 profili per ampliare la squadra che si occupa dello sviluppo dei motori diesel per i modelli del Gruppo GM, all’interno del centro “GM Powertrain Europe” di Torino. Gli ingegneri (principalmente meccanici, elettronici e meccatronici) saranno inseriti nell’area motori diesel e nell’area sistemi di controllo.  

Il GM Engineering Centre si trova nella Cittadella Politecnica di Torino. GMEC sta sviluppando una nuova generazione di motori diesel a basso consumo di carburante, di controlli e nuovi sistemi di propulsione avanzati, come ad esempio gli ibridi diesel, che miglioreranno l'efficienza del carburante, ridurranno le emissioni. 

Si può presentare la propria candidatura attraverso la pagina dedicata: http://www.adecco.it/it-IT/spazio-candidati/aziende-che-assumono/general_motors/Pages/GM-profilo-aziendale-italiano.aspx

Queste le figure ricercate:

Area Controls

- Hardware in the Loop Application Engineer
- Hardware Electronic Package Engineer
- Control System Development Engineer
- Algorithm Development Engineer
- Technology System Engineer
- Controls Design Responsible Engineer
- Hardware Electrical Architecture Development Engineer
- Control System Safety Engineer
- Basic SW Development Engineer
- Controls Integration Testing Engineer
     
Area Diesel Development

- Design Engineer
- Analysis & Simulation  Engineer
- Benchmarking Engineer
- Base Hardware Development Validation Engineer
- CFD 3D Analyst
- Senior System Development & Base Calibration Engineer
- Design Release Engineer – Base Engine
- Design Release Engineer - EMS
- Cost Engineer
- Record & Release Analyst
- Engine Performance Vehicle Systems Engineer
- Engine Subsystem Dynamic Analysis Engineer
- Benchmarking Engineer
- Noise Engineer
- Lead Noise Engineer
- Structural Dynamic Analysis Engineer
- Fuel Injection System Design Release Engineer
- CFD 3D Thermal Management Analysis Engineer
- CFD 3D Air Flow Analysis Engineer
- Senior Technology System Engineer-Thermal Management

Area Test Facilities

- Operatori Sala Prova
- Laboratory Engineer
- Instrumentation and equipment calibration Engineer
- Powertrain Emission Instrumentation Engineer
- Test Equipment Engineer

Altre

- Project Buyer
- Program Coordinator
- Supplier Quality Engineer
- Health & Safety Site Coordinator
- Budget Administrator